Front Spring Installation Tool 1979-2004 Mustang
1994 to 2004 Mustang
- Gift Ideas & Accessories
- Books and Manuals
- Brakes
- Convertible
- Cooling System
- Custom Tuning and Calibration
- Decals
- Differential
- Electrical
- Engine
- Exhaust
- Exterior
- Fuel System
- Heat and Air Conditioning
- Ignition
- Interior
- Lubricants
- Stripes and Decals
- Suspension and Steering
- Transmission
- Trunk Area Parts
- Turbochargers
- Weatherstripping and Rubber Parts
- Wheel and Tire
- Windshield Wiper and Washer Parts
Click Any Photo to Enlarge
This MM tool is invaluable when installing lowering springs on the front of your Mustang. This tool bolts to the front control arm, and guides the bottom coil of the spring into its proper position on the control arm as it is swung into place with a floor jack. The tool is then easily dismounted from the control arm and removed through the access hole in the arm. The often-frustrating task of spring installation is made quick and easy with this Maximum Motorsports tool.
Note: Not for use with stock Mustang springs because of their long free length. A spring compressor is required to install stock springs.
Note: While spring installation in 1994-2004 Mustangs is easier than in 1979-93 Mustangs because later cars have longer front control arms, this MM tool may still be a valuable asset.
Manufactured / Distributed By:
Also Found in:
